Replace VW T6 / T6.1 Front Emblem – Step-by-Step Guide for the Grille Badge
|
Time to read 2 min
|
Time to read 2 min
You want to replace the VW emblem on your T6 or T6.1 to give your van a fresh look?
No problem! In this guide, we’ll show you step by step how to replace the logo on the front grille – no stress and no need to visit a workshop. Whether you want to install a black badge or another version, here’s what you need and how to get it done quickly and easily.
Since 2019, we at MazorDesign have stood for top quality and expertise when it comes to refining original emblems for vehicles like the VW T6 and T6.1. Our many years of experience in producing and replacing logos have given us comprehensive know-how in this area. We know every detail and exactly what matters to give your van the perfect finish. From choosing the right parts to refining them in our own workshop near Nuremberg – we stand for the highest quality. As car enthusiasts, we know how important perfect fit and durability are. That’s why we’re happy to share our know-how so you can easily handle the conversion yourself.
To safely and damage-free remove the badge on your VW T6 or T6.1, it's essential to use plastic pry tools. Also known as trim tools, panel removers or molding levers. These tools allow you to gently loosen the clips of your front emblem without damaging the logo or the grille.
Placing the tool: Insert the plastic pry bar at the top between the grille and the logo. Be sure to push the lever as deep into the gap as possible to create good leverage.
Prying off the VW logo: Gently pry off the badge by slightly pressing the lever upward. Once one section is loosened, move along the edge of the badge bit by bit.
Continue around the edges: Repeat this step all around until all locking points are released. Be careful not to apply too much pressure to avoid damage.
Tip: Use the back of your new emblem to see where the locking clips are located
Removing the VW logo: Once it’s fully loosened, you can carefully remove the logo.
Note: A loose base plate lies underneath the badge. Make sure it doesn't fall, as it’s not fixed in place.
Prepare the base plate: Carefully place the base plate exactly in the designated area, directly below where the badge will go. Make sure it fits correctly and doesn't slip.
Align the logo: Position the new part so the clips of the badge align with the cutouts in the grille. Take your time to ensure all hooks are seated properly.
Press in the VW badge: Gently but firmly press all around the badge until all clips are securely locked in place. Check that the badge sits flush and no gaps are visible.
→ T6 / T6.1 Rear Emblem install
→ T6.1 Side Plaques install (coming soon)
Whether on the front grille, the fender or the rear tailgate – our logos give your VW a timeless elegance. Make the difference visible and choose quality that speaks for itself.
Get your upgrade and give your vehicle the classy look it deserves! 🏆